DK Digital CDB-600 Especificações Página 20

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 68
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 19
Chapter 6 The Extended Audio Matrix. PRELIMINARY Release MSD Software Manual.
6.4.2.2 Adjust Output Gain for an Audio Group.
To adjust the output gain of an Audio Group, use the [] / [] keys to move
the cursor to the ‘G-GAIN’ column and then use the use the [] / [] keys to
move the cursor to an output that is in the group where the gain is to be
adjusted. Press the [Option] key to enter the ‘Output Gain’ menu. In the
‘Output Gain’ menu use the [] / [] key to adjust the output gain and then
press [Exit] when done.
The output gain can be adjusted in steps of 0,5 dB between –12,0 dB and
+12,0 dB.
Note for PT0660M users: Using the wheeler in the main menu in full feature
mode will adjust the group gain for the Master group.
6.4.3 SUM and Difference amplifier. (M-S Mode.)
Even though most material today is produced in stereo, it is still important to
have information about the mono compatibility of the stereo signal. There are
different ways to measure this.
A way to do this, is to sum the two signals (left and right) together with a
differential showing of the same signal pair. By showing these as PPM-
bargraphs next to the stereo pair (M-S meters), it is possible to show the
differential between the M (sum) and S (difference) and from that measure the
mono compatibility. The further these two readings travel from each other, the
likelihood is that the signal is going out of phase.
In the illustration above a 1 KHz
sinewave with a phase difference
of 0 degrees is applied to channel
1 and 2. When the signal is
completely in phase the SUM of
the signal will be doubled.
In the illustration above a 1 KHz
sinewave with a phase difference
of 180 degrees is applied to
channel 1 and 2. When the signal
is completely out of phase the
DIFFERENCE of the signal will be
doubled.
Please refer to section 7.1 and 7.2.1 for information on how to use the 'Phase
Correlation Meter' and the 'Audio Vectorscope' to show the phase relationship
between two channels.
Page 16 of 64. PRELIMINARY Release
Vista de página 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 67 68

Comentários a estes Manuais

Sem comentários