DK Digital CDB-700 Manual do Utilizador descarregar pdf (Página 49)

Page 49 of 108

Unlocking the plug/smart cable lock

Using a tool, release the lock (must be from the side shown) by pushing the tap

(through the small slot in the side of the lock).

At the same time, turn the lock 90º in either direction to release the plug connection.

Flanges in locked position

Fig. 1

Press here with tool

No tap on this side

Turn to open

Fitting the plug/smart cable lock

Step 1:

The three ﬂanges in this position indicate that

the “smart cable locking” device is in the

unlocked position.

Step 2:

Position and press the cable plug into

the socket.

Fig. 2

Step 3:

Hold around the lock ﬂanges and turn the lock either

clockwise or anticlockwise.The cable is fully locked when

turned 90°.

Turn 90°

Fig. 3Fig. 1

Warnings!

• The actuator must not be subject to a sideways load, as this can cause bending. It is also for this reason that the actuator should not be used as a handle.

• The actuator must not be subject to moment loading, as this can damage the actuator.

• The actuator must not be subject to impact or blows, or any other form of stress to the casing.

• The actuator must not be subject to overload, as this can reduce the lifetime of the actuator and in the worst case cause damage to the actuator.

• The LA44 must not be used in pull applications, as this can cause collapse.

• Do not hold the inner or outer tubes when the actuator is running due to danger of squeezing.

• Do only use the actuator within specified working limits.

• It´s not allowed to adjust the Build-in dimension by turning of the inner tube. This might cause collapse of the actuator.

Recommendations

• It is recommended that the actuator is serviced according to the relevant national norms for the applications in which the actuator is used.

• Connection bolts must be dimensioned so that they have the necessary strength in order to obtain the minimum safety factor according to the

requirements of the authorities.

• Connection bolts and brackets are to be inspected in connection with service, and must be replaced if there are signs of wear and tear.

• The safety function: Electrical Spline, should be checked in connection with service. The function is checked by applying a straight pull, of max.

100 N, to the back fixture. The actuator must not be able to run in an inward direction. Hereafter press the back fixture against the housing and

the actuator can run in an inward direction.

• The actuator should be cleaned regularly, in order to maintain a good hygiene.

• Inspect the actuator minimum once a year for wear and jarring sound

Fig. 1. Manual Lowering

In case of a power failure it is possible to mechanically lower a patient placed in a patient hoist. When turning the

manual lowering handle clockwise the actuator can be moved fully inwards.

Manual lowering:

The following pictures illustrate a) The manual lowering procedure and

b) How to ﬁt and remove the plug connection using the “Smart cable lock”

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 107 108

Comentários a estes Manuais

Sem comentários

DK Digital CDB-700 Manual do Utilizador Página 49

Comentários a estes Manuais

Manuais e produtos relacionados com não DK Digital CDB-700