DK Digital CDB-700 Manual do Utilizador descarregar pdf (Página 91)

Page 91 of 108

Safety concept:

DC power is only on the application when needed – when the hand control is activated.

The user is part of a safety concept with light indications showing:

Connected to the mains

Green light when connected to the mains

Power request

Yellow light at power request when the hand control is activated

Check of functionality

Yellow light is turned off when releasing a hand control button – otherwise the

hand control or other components in the application are defective. If so, the user

must call for service.

The SMPS30 is designed for placing on the ﬂoor, but it can also be mounted on the wall / application via the bottom base plate

and 4 screws.

If the SMPS30 is mounted on the wall/application, please dismount the SMPS30 to get access to the cable locking mechanism on the mains cable.

Recommendations

Please note

The SMPS30 is only compatible with LA43 IC and the LA44 IC.

The SMPS30 is not suitable for outdoor applications

Before installation, re-installation or troubleshooting

• Stop the application

• Switch off the power supply and pull out the mains plug

• Relieve the application of any loads, which may be released during the work

Before start-up

• Make sure that the system has been installed as instructed in the User Manual

• System connection. The individual parts must be connected before the SMPS30 is connected to the mains.

During operation

• Ensure that the cables are not damaged

• Unplug the SMPS30 before moving the equipment

Device protection:

The SMPS30 contains several mechanisms to protect itself from being damaged due to excessive use.

• In case of overheating, the device will activate a thermal protection. No power output will be available until the temperature is back again within

normal operating range.

• In case of exceeding the current limit / failure in the actuator, the device will activate an overload protection. Immediately after the situation has

been remediated the power output will be available again.

Hot plugging

• It is not allowed to remove or to add the output cable as long as the SMPS is powered by mains.

Maintenance/cleaning

• The SMPS30 must be cleaned at regular intervals to remove dust and dirt and it must be inspected for mechanical damage, wear and breaks

• It is not allowed to spray directly with a high-pressure cleaner on the device

• Interconnecting cables must remain plugged in, correctly ﬁtted with O-rings, during cleaning to prevent ingress of water

• The SMPS30 is resistant to the majority of cleaners and disinfectants used in the hospital and nursing home sector.

However, the detergents must comply with the following basic requirements

- They must not be highly alkaline or acidic (pH value 6-8)

- They must not contain caustic agents

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 107 108

Comentários a estes Manuais

Sem comentários

DK Digital CDB-700 Manual do Utilizador Página 91

Comentários a estes Manuais

Manuais e produtos relacionados com não DK Digital CDB-700