DK Digital CDB-700 Manual do Utilizador descarregar pdf (Página 79)

Page 79 of 108

Recommendation:

• Violent use of the key on HL80 can cause either damage to the keyhole or the key itself.

• If a lock key is missing, then full control over the application could be missing.

• Clean the handset regularly to ensure good hygiene standards.

• When a defective Hx80 is replaced, check that the new Hx80 has exactly the same specification and fuctionality.

• Do not submerge the handset under water.

• Unless otherwise specified or agreed by LINAK, the handset is only intended to be used on LINAK systems.

• When changing handsets for OpenBus™ systems, the power must be switched off.

• It is recommended to check the handset and cable for damage and holes made by violent handling before washing the application or at least

once a year.

• It is recommended to have a parking place for the handset on the application, where the customer ensures that the handset does not fall off.

For handsets with magnet:

• If handsets with magnet are attached to a smooth surface, a movement or twisting of the cable, for example during transport, can cause the

handset to move and result in damage if the cable is squeezed.

• The force of the magnet depends on the thickness of the lacquering, the lacquering type, stickers, steel thickness etc. It is the responsibility of the

customer to verify that the holding force on the application is acceptable.

• It is the responsibility of the user/operator to evaluate any possible risk caused by use of permanent magnets.

22. IRO (MEDLINE

CARELINE

)

The IRO (Infrared Receiver OpenBus™) has been developed as a part of the accessory portfolio to be available

for the CB OpenBus™ family. The receiver is ﬁtted to the bed so that the bed movement can be controlled with

signals received from a remote control (C-type Transmitter).

Warning!

• Inform the customer that other handsets/equipment that use a protocol similar to parts of the LINBUS protocol for communication, may have

influence on movement of the application

• Inform the customer that:

- a damaged or a dirty IR window will reduce the receiving sensitivity

- foreign object must not block the visual line from transmitter to the IRO receiver,

- the IRO must be mounted for optimal visual receiving ability

• Inform the customer that interference from other light sources (38 KHz +/- 5 %), e.g. neon light, sunlight or toys may cause a temporary stop in a

movement

• The customer has to mount the IRO at a protected location in the application

• Inform the customer to use the torque 1.5-2.0 Nm for mounting the IRO on the application

23. LS (MEDLINE

CARELINE

TECHLINE

)

There are two types of LINAK limit switches, for actuators type LA22, LA30, LA30S , LS, and LSD.

The LS type gives a signal in two ﬁxed end positions, but requires a control unit to stop the actuator when the

microswitches are activated.

24. LSD (MEDLINE

CARELINE

TECHLINE

)

The LSD type controls the stroke length of the actuator between two ﬁxed end positions by cutting off the current

to the motor.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 107 108

Comentários a estes Manuais

Sem comentários

DK Digital CDB-700 Manual do Utilizador Página 79

Comentários a estes Manuais

Manuais e produtos relacionados com não DK Digital CDB-700