DK Digital CDB-700 Manual do Utilizador descarregar pdf (Página 22)

Page 22 of 108

2. Information on start-up, de-installation and operation

Before installation, de-installation, or troubleshooting:

• Stop the actuator/lifting column.

• Switch off the power supply or pull out the mains plug and pull out the plug to the actuator/lifting column.

• Relieve the actuator/lifting column of any loads, which may be released during the work.

Prior to ﬁrst use of LINAK batteries, please make sure that they are being charged 24 hours in order to reach proper function and prolong the lifetime

of the batteries.

Before start-up:

• Make sure that the system has been installed as instructed in the User Manual.

• The individual parts (actuator/lifting column/handsets etc.) must be connected before the control box is connected to the mains.

• Make sure that the voltage of the mains to be connected to the product or the system is the one stated on the label.

• Make sure that the actuator/lifting column is connected to a mains electricity supply/transformer with the correct voltage and which is dimensioned

and adapted for the actuator in question.

• The equipment can be freely moved over the actuator/lifting column’s whole working area.

• Check correct function after mounting.

• The actuator/lifting column must not be loaded in excess of the values indicated in the speciﬁcations on the product label.

• The duty cycle noted on the product label must always be noted. Otherwise there is a risk of damaging the products.

Exceeding the duty cycle will result in a dramatic reduction of the life time of the system.

Unless speciﬁed otherwise on the product label the duty cycle is max. 10% : Max. 2 minutes in use followed by 18 minutes not in use.

• The actuator/lifting column system may only be used in an environment corresponding to the system’s IP-rating.

LINAK products are marked with the actual IP-rating on the label.

• If any individual parts are suspected to be damages, do not install the parts, but return them for inspection/service.

During operation:

• Listen for unusual sounds and watch out for uneven running. Stop the actuator/lifting column immediately if anything unusual is observed.

• If the control box makes unusual noises or smells, switch off the mains voltage immediately and the external battery, if any.

• Take care that the cables are not damaged.

• Unplug the mains cable on mobile equipment before it is moved.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 107 108

Comentários a estes Manuais

Sem comentários

DK Digital CDB-700 Manual do Utilizador Página 22

Comentários a estes Manuais

Manuais e produtos relacionados com não DK Digital CDB-700