DK Digital CDB-700 Manual do Utilizador descarregar pdf (Página 8)

Page 8 of 108

Do not connect the positive terminal and the negative terminal of the LINAK battery packs with a wire or other metals. Short-circuiting

the terminals of the battery can cause burn injuries, damage to the storage battery or trigger explosions.

Never connect the LINAK battery packs directly to a power supply socket or an automobile’s cigarette lighter without using a charger

as a medium. Connecting the battery directly can cause the battery to leak ﬂuid, generate heat, explode, cause ﬁres or bodily burns and

injuries.

LINAK battery packs contain dilute sulphuric acid, which is a toxic substance. If the battery’s internal ﬂuid leaks out and gets onto your

skin or clothing, make sure it is washed off with clean water. Additionally, if the ﬂuid gets in your eyes, wash them with clean water

immediately, and see a doctor. When dilute sulphuric acid gets in your eyes, it can cause a loss of eyesight and when it gets on your skin,

it can cause a burn on your skin.

Do not use or store LINAK battery packs where the surrounding temperature exceed 50°C, such as inside a hot automobile, in direct

sunlight, or in front of a stove or a source of intense heat. Doing so can shorten battery life, lower its performance level, cause the battery

to leak ﬂuid, be damaged or deformed.

For actuators without plugs, which are not connected to a LINAK control box, the mains supply or the actuator must always be equipped

with an arrangement that switches off the actuator at the end-stop, for example, LS or LSD limit switch. If there is a risk of overloading

the actuator, the mains supply must be equipped with a safety device against overloading (for example a CS16-PCB). If these precautions

are not observed, the actuator can be damaged.

The LINAK products cannot tolerate the inﬂuence of strong solvents, basic or alkaline liquids.

Non-LINAK handsets

LINAK handsets are designed specially for LINAK control boxes, and they are designed to be highly reliable and ﬂexible. If the customer

still wishes to use his own handset, it is important to contact a LINAK sales person to ﬁnd out the requirements with regard to the

switches in the handset. Poor switches can destroy the control box.

The duty cycle printed on the label of the control box must always be noted. If this is exceeded, there is a risk of the control box being

overheated and damaged. Unless otherwise specified on the label, the duty cycle is max. 10% : max. 2 min. in use followed by 18 min.

not in use. Exceeding the duty cycle will result in a dramatic reduction of the product.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 107 108

Sem comentários

DK Digital CDB-700 Manual do Utilizador Página 8